Logo

P12BE Engine Trouble Code

Meaning of P12BE engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P12BE Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for P12BE code is occuring now you should check P12BE repair processes.
Now don't ask yourself; What should you do with P12BE code ?
The solution is here :

P12BE Possible Solution:

P12BE Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

P12BE Code Meaning :

P 1 2 b e
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Fuel And Air Metering Manifold Absolute Pressure/Barometric Pressure Circuit High Input

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P12BE OBD-II Diagnostic Powertrain (P) Trouble Code Description

P12BE engine trouble code is about .

Main reason For P12BE Code

The reason of P12BE OBD-II Engine Trouble Code is Manifold Absolute Pressure/Barometric Pressure Circuit High Input.

P12BE DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.